Author Topic: Can I use dc10+ in NT? Scooby
posted 05-20-2000 07:27 PM
well?

------------------
fxscooby
DreamFX


Benny
posted 05-21-2000 07:42 PM
I dont see why that should be a problem. Isn't DC10+ supported by NT.. I think so anyway..

------------------
.Benny.
.CGI & Film Director.
.Taurus Filmproductions.
http://taurusfilmprod.hollywood.com/

Email me:
C_Keeper@hotmail.com

ntprod
posted 05-23-2000 08:29 AM
Actually I don´t think that there are any DC10+ drivers for NT. There have been alot of discussion on this topic at www.pinnaclesys.com and I belive that the answer from pinnacle was that the DC10+ is not considered to be professional card and therefor NT is not supported. They recommended everybody that wanted NT driver to buy DC30+. However they said something about maybe put out some 2K drivers. I would recommend you to visit their site and ask.

------------------
Life is what happens to you when you´re busy making other plans

bastipictures VFX
posted 05-24-2000 06:35 AM
Hey Scooby!

I think it should work. Im using the DC 30 with NT and it works properly (can u say that?-properly?- I dont know!?). There were a lot of problems after installing the board into my workstation. My PC doesnt want to find the card. But i downloaded the newest drivers (DC 30 series for DC 30, DC30 + and so on) and finally it worked. But You cannot capture in Premiere. Just with the pinnacle capture tool.
Maybe there is a driver like 'DC 10 series'
which would work for you.

Basti

------------------
P.S.:Excuse my bad english but i'm a 16 years old german pupil!

Sebastian Stanek
[BastiPictures VFX]

http://bastipictures.notrix.de

bastipictures VFX
posted 05-24-2000 06:38 AM
Ooops I have to refresh my signature!
I'm seventeen since yesterday

All times are ET (US)